TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 23 of 30)
36.
Position new gasket (Y) and assembled cap (W)
and seal (X) onto case (U).
37.
Apply primer to all threaded holes in case (U).
38.
Apply sealing compound (Item 7, Appendix B) to
threads of eight screws (Z). Using 3/4 inch
socket, install eight screws (Z) to secure cap
(W).
WARNING
Wear gloves when handling frozen
parts to prevent serious injury to your
hands.
39.
Remove one bearing (S) from refrigerant and
quickly install in carrier (N) bearing pocket (V).
Ensure bearing (S) is seated in bearing pocket
(V).
40.
Remove second bearing (S) from refrigerant and
quickly install in case (U) bearing bore (T).
Ensure bearing (S) is seated in bearing bore (T).
41.
Using inspection mirror, ensure bearings (S) are
fully seated in bearing pocket (V) and bearing
bore (T). If bearings (S) are seated, go to step
43. If bearings (S) are not seated, go to step 42.
42.
If bearing (S) is not seated in carrier (N), using
bearing mechanical puller kit, remove bearing
(S) from carrier (N). Repeat steps 33, 39, and
41. If bearing (S) is not seated in case (U),
using universal mechanical puller, remove
bearing (S) from case (U). Repeat steps 33, 40,
and 41.
CAUTION
If staking of bearing (S) is required,
do not hit bearing with punch or
hammer.
Damage to the bearing
could result.
43.
Check bearing (S) for looseness. If loose, using
hammer and center punch, stake bearing (S)
pocket in three places to hold bearing (S) in
place during assembly.
Go on to Sheet 24
Change 5 7-23
