TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 24 of 30)
44.
Install inner race (AA) on pinion gear (AB) with
flange toward gear segments.
45.
Place race (AA) and pinion gear (AB) in press
with splined end up.
46.
Apply pressure to splined end of pinion (AB) until
race (AA) is seated on pinion gear. Release
arbor press pressure.
47.
Install second race (AC) on pinion gear (AB).
Place 10 inch section of 3-1/8 inch I.D. pipe
over splined end of pinion (AB) so pipe engages
race (AC).
48.
Using arbor press, apply pressure to pipe until
race (AC) is fully seated on pinion bearing
shoulder.
NOTE
If output bearing or gear set was
replaced, go to step 49. If bearing or
gear set was not replaced, the
bearing is still on the drive gear; go
to step 54.
49.
Lightly grease drive gear (AD) mating surface.
50.
Position drive gear (AD) in arbor press on
supporting material.
51.
Position bearing (AE) on drive gear (ADs
52.
Position bearing installer over drive gear (AD)
shaft on bearing (AE) inner race.
Go on to Sheet 25
Change 3 7-24
