TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 20 of 30)
17.
Apply light coat of grease to machined surface of
output shaft (A).
18.
Position bearing (M) on output shaft (A).
19.
Using two persons, or lifting device, position
output shaft (A) in arbor press.
20.
Place one output shaft bearing installer over
output shaft (A) with small opening facing
bearing (M). Bearing installer must engage
bearing (M) inner race.
21.
Place second output shaft bearing installer over
output shaft (A) with large opening facing first
bearing installer.
22.
Place metal block on bearing installer.
23.
Aline output shaft (A) under arbor press ram.
24.
Apply arbor press pressure to seat bearing (M)
on output shaft (A).
25.
Release pressure. Remove metal block and two
bearing installers.
Go on to Sheet 21
7-20 Change 3