TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 21 of 30)
26.
Position carrier (N) on wood blocks.
27.
Place new gasket '(P) on carrier (N). Aline
holes.
28.
Using suitable lifting device, install assembled
shaft (A) into carrier (N). It may be necessary to
tap sides of carrier (N) to seat shaft. Make sure
gasket (P) is on screws (Q) and screws line up
with holes in carrier '(N).
29.
Using 3/4 inch wrench, tighten eight screws (Q).
Using torque wrench with crowfoot, tighten
screws to 90-130 lb-ft (122-176 N.m).
30.
Install lockwire in pairs on screws (Q).
31.
Using suitable lifting device, turn carrier (N) over
and support with wood blocks for further
assembly.
32.
Install spacer (R) onto output shaft (A) assembly,
wide end towards output shaft flange.
Go on to Sheet 22
Change 3 7-21