TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 18 of 30)
91. Inspect output shaft bearing (AT) and drive gear
bearing (AS) for serviceability in accordance with
TM 9-214. Replace bearings as necessary. If
bearing (AS) must be replaced, refer to steps 73
thru 77 for removal of bearing from drive gear
(U).
ASSEMBLY:
NOTE
When installing preformed packings or o-rings, ensure there are no burrs, nicks, or sharp edges
which could cut or damage these parts during installation. Use oil (Item 16, Appendix B) to
lubricate both packings (o-rings) and parts for ease of installation.
1. Apply adhesive to output shaft (A) in area
indicated, and to five output shaft holes, 1/8 inch
below flange surface.
NOTE
Preformed packing (B) is part of late
model spacers (C).
If preformed
packing (B) is installed on spacer (C),
go to step 3.
2. Apply oil to preformed packing (B) and install on
spacer (C).
3. Install spacer (C) onto shaft (A), with wide
portion toward shaft flange, and seat spacer (C)
against flange.
Go on to Sheet 19
Change 5 7-18