TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 19 of 30)
4.
Apply oil to preformed packing (D) and install
onto special tool oil seal replacer (E).
5.
Install oil seal replacer (E) over splined end of
shaft (A) with preformed packing end down.
Push replacer down to bearing surface of shaft.
6.
Roll preformed packing (D) off replacer (E) and
onto shaft (A).
7.
With replacer (E) in same position, carefully
press preformed packing (D) into recessed area
between spacer (C) and shaft (A).
Seat
preformed packing (D) flush or below top edge
of spacer (C).
8.
Remover replacer (E) from shaft (A).
9.
Using clean, lint-free rag, wipe both inner and
outer parts of seals (F) and (G) to remove any
foreign material. Apply oil to surfaces of seals
(F) and (G).
10.
Apply oil to o-ring (H). Install o-ring (H) on spring
seal (G).
11.
Install spring seal (G) in cap (J) with four pins
thru four holes in cap (J).
12.
Place seal (F) over output shaft (A). Aline seal
(F) hole with output shaft (A) pin and press down
to engage spacer (C).
13.
Install eight bolts (K) in ring (L).
14.
Using two persons, lift ring (L) and position on
output shaft (A).
15.
With cap (J) seal side facing spacer (C), place
cap (J) over spacer (C) with eight bolts (K) thru
eight holes of cap (J).
16.
Grasp cap (J) and press down firmly. Cap (J)
will spring back when properly installed.
Go on to Sheet 20
Change 3 7-19
