TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 27 of 30)
66.
Using torque wrench, tighten eight screws (AJ)
to 50-60 lb-ft (68-81 N.m) in sequence shown.
67.
Using torque wrench, retighten screws (AJ) to
95-115 lb-ft (129-156 N.m).
68.
Install lockwire in pairs.
69.
Position carrier (N) on wood blocks.
70.
Place new gasket (AK) onto carrier (N).
71.
Using suitable lifting device, position case (U)
over carrier (N).
72.
Carefully guide pinion gear (AB) thru bearing and
seal in case (U) and aline case with dowel pins
(AL) in carrier (N). Apply pressure evenly to
mate case (U) with carrier (N).
73.
Install three bolts (AM) through carrier (N) into
case (U) to keep units together.
Go on to Sheet 28
Change 5 7-27