TM 9-2350-222-20-1-5
MOLDBOARD LOCKING HOOKS AND SHAFT REPLACEMENT (Sheet 5 of 6)
INSTALLATION:
Install shaft (A) into brackets (B) and (C). Push
1.
shaft through bracket (C) while leaving in
bracket (B).
Using hammer, install arm (D) onto shaft (A)
2.
up to groove in shaft (A).
Install woodruff key (E) into groove in shaft (A).
3.
Install arm (D) over woodruff key (E).
4.
5.
Install screw and new lockwasher (F) onto arm
(D).
Using 3/4 inch wrench, tighten screw (F).
6.
7.
Using hammer and brass drift, drive shaft (A)
out of bracket (B) into bracket (C).
Place hook (G) into bracket (B) as shown and
8.
push shaft (A) through bracket (B) and hook
(G). Make sure flat end of shaft (A) is in top
position.
9. Using hammer and brass drift, drive shaft (A)
out of bracket (C).
10. Install hook (H) into bracket (C) as shown.
11. Using hammer on brass drift, drive shaft (A)
back into bracket (C) and through hook (H).
Make sure flat end of shaft is in up position.
Go on to Sheet 6
TA141126
