TM 9-2350-222-20-1-5
LINEAR ACTUATING (RAM) CYLINDER AND GUARDS REPLACEMENT (Sheet 3 of 8)
9.
Using 1-1/4 inch wrench on nut of hose
assembly (J) and 11/ 16 inch wrench on nut of
adapter (N), remove hose assembly and install
plastic plug and cap to prevent entry of dirt.
Using 11/16 inch wrench, remove adapter (N).
10.
Using 1-1/2 inch wrench, remove bushing (P).
11.
Using 1-1 /4 inch wrench on nut of hose
12.
assembly (K) and 11/ 16 inch wrench on nut of
elbow (Q), remove hose assembly and install
plastic plug and cap to prevent entry of dirt.
13.
Using 15/16 inch socket, remove screw (W),
lockwasher (X), and lock (Y). Throw lockwasher
away.
14.
Pull out and remove pin (Z) from rod and
pushbeam.
15.
Using 1-1/2 inch socket, remove four bolts,
lockwashers (AA), and two caps (AB). Throw
lockwashers away.
16.
Attach sling and, using lifting device, remove
cylinder (V) from vehicle and place on work
bench. Remove lifting device and sling.
Go on to Sheet 4
TA14113
18-28
