TM 9-2350-222-20-1-5
MOLDBOARD LOCKING HOOKS AND SHAFT REPLACEMENT (Sheet 1 of 6)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Inspection
Installation
TOOLS: 12 in. adjustable wrench
1/2 in. combination box and open end wrench
3/4 in. combination box and open end wrench
Diagonal cutting pliers
Sledge hammer
Brass drift, 1 in. dia., 10 in. lg.
1/8 in. drive punch
SUPPLIES: Cotter pin (MS24665-353)
Sandpaper (Item 51, Appendix D)
Paper
Pencil
Lockwasher (MS35338-48)
REFERENCE: TM 9-2350-222-10
PERSONNEL: Two
PRELIMINARY PROCEDURES:
Lower moldboard to ground (TM 9-2350-222-10)
Remove guards from right and left hydraulic ram cylinders
Remove left front fender support assembly (page 16-65)
Go on to Sheet 2
TA141122
