TM 9-2350-222-20-1-5
LINEAR ACTUATING (RAM) CYLINDER AND GUARDS REPLACEMENT (Sheet 2 of 8)
NOTE
This task is for left cylinder and
guards. The procedure for right
cylinder and guards is the same.
WARNING
Guards are heavy. Use care when
removing.
1.
Using 3/4 inch socket, remove four screws,
Throw lockwashers away.
2.
Using 3/4 inch wrench, remove four screws,
Throw lockwashers away.
Using 3/4 inch socket, remove four screws,
lockwahers, washers (E), and front guard (F).
Throw lockwashers away.
4.
Using 15/16 inch socket, remove two screws,
lockwashers (G), and cover (H). Throw
lockwashers away.
5.
Place container under hose assemblies (J) and
(K) to catch fluid (at the hull disconnect end of
hose).
6.
Using 1-1/4 inch wrench, disconnect nuts on
end of hose assemblies (J) and (K) and allow
fluid to drain.
Using 1-3/8 inch wrench, loosen two nuts (L)
7.
and using adjustable wrench on elbows (M),
remove two elbows, nuts, and packings (under
nuts). Throw packings away.
Remove container and throw away fluid.
8.
TA141129
18-27