TM9-2350-222-20-1-3
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 5 of 8)
26. Traverse turret to position gun tube to front for access to engine compartment (TM 9-2350-222-10).
27.
Insert 1/8 inch diameter locating pin (W)
through alinement hole of remote control lever
(X). If locating pin cannot be inserted, perform
steps 28 through 34. If locating pin can be
inserted, go to step 34.
28.
Using 7/16 inch wrench to hold rod end bearing
(Y) (on flats), use 1/2 inch wrench to loosen nut
(Z).
Using 7/16 inch wrench, remove screw (AA).
29.
Insert locating pin (W) through alinement hole
30.
into housing (AB).
NOTE
If rod (Y) cannot be adjusted short
e n o u g h for screw (AA) to slip
freely through lever (X), push rod
(Y) forward and insert screw (AA).
Turn rod end bearing (Y) until screw (AA) slips
31.
freely through remote control lever (X) and rod
end bearing.
Using 7/16 inch wrench to hold rod end bearing
32.
(Y), tighten nut (Z).
Using 7/16 inch wrench, tighten screw (AA).
33.
Remove locating pin (W).
34.
Go on to Sheet 6
TA141447
7-419