TM9-2350-222-20-1-3
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 3 of 8)
10.
Close turret platform access door. Traverse turret to position gun tube to rear for entry to
driver's compartment (TM 9-2350-222-10).
1.
Insert 1/8 inch diameter locating pin (L)
BEHIND FIRE EXTINGUISHER BRACKET
through alinement hole of remote control lever
(M). If locating pin cannot be inserted, perform
steps 12 thru 17. If locating pin (L) can be
inserted, go to step 18.
12.
Using pliers, remove cotter pin and pin (N).
Throw cotter pin away.
13.
Using 1/2 inch wrench to hold clevis (P), use
1/2 inch wrench to loosen nut (Q).
14.
Position remote control lever (M). Insert
locating pin (L) from behind.
NOTE
If necessary, remove locator pin (L)
and push remote control lever (M)
forward to allow clevis (P) to turn.
Then repeat steps 14 and 15.
15.
Turn clevis (P) until pin (N) slips freely into
remote control lever (M).
16.
Using pliers, install new cotter pin through pin
(N).
17.
Using 1/2 inch wrench to hold clevis (P), use
1/2 inch wrench to tighten nut (Q).
Leave locating pin (L) in position until step 36.
18.
Go on to Sheet 4
TA149113
7-417