TM9-2360-222-20-1-3
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 7 of 8)
43.
Stop engine (TM 9-2350-222-10).
Insert either end of go/no-go gage (AB) between
44.
stop pin (AF) and bracket (AG). Hold in this
position while person in driver's station presses
pedal to full throttle position.
With pedal in full throttle position, screw (AH)
45.
must contact floor and stop pin must contact
either end of go/no-go gage (AB). If this
requirement cannot be met, do steps 46 thru 48.
If requirement is met, go to step 49.
46.
Using two 9/16 inch wrenches, loosen jamnut
(AJ) and screw (AH) on back side of accelerator
pedal (AK).
47.
Using two 9/16 inch wrenches, hold screw (AH)
and tighten jamnut (AJ),
Go on to Sheet 8
TA141449
7-421