TM9-2350-222-20-1-3
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 1 of 8)
Long round nose pliers
TOOLS:
9/16 in. combination box and open end wrench (2 required)
1/2 in. combination box and open end wrench (2 required)
7/16 in. combination box and open end wrench
Flashlight
Throttle linkage adjusting go/no-go gage (Figure F-3, AppendiX F)
FABRICATED TOOLS:
1/8 in. dia. by 2 by 4 in. long locating pin (2 required)
SUPPLIES:
1/16 in. dia. by 2 in. long pin
Cotter pin (MS24665-281) (3 required)
Cotter pin (MS2466S-132) (1 required)
PERSONNEL: Two
TM 9-2350-222-10
REFERENCE:
Place shift lever in P (park) position (TM 9-2350222- 10)
PRELIMINARY
PROCEDURES:
Block tracks to prevent vehicle movement (TM 9-2350-222-10)
Remove upper engine access cover (page 16-40)
Remove driver's escape hatch (page 16-133)
TA253320
Go on to Sheet 2
Change 1 7-415