TM9-2350-222-20-1-3
MANIFOLD HEATER FUEL FILTER ELEMENT AND INPUT FUEL LINE REPLACEMENT
(Sheet 8 of 8)
Fuel Filter Input Fuel Line Replacement (Sheet 1 of 1 )
TOOLS:
1/2 in. combination box and open end wrench
5/8 in. combination box and open end wrench
SUPPLIES: Plastic tubing (70178261), 7.125 in lg.
Nut (189894) (2 required)
Sleeve (18991 1 ) (2 required)
Clean bucket or drip pan
Rags (Item 65, Appendix D)
REFERENCE: TM 9-2350-222-10
Remove lower engine access cover (page 16-41)
PRELIMINARY PROCEDURE:
REMOVAL:
CAUTION
When removing or installing fuel lines, care must be taken not
to damage fittings and threads or twist or distort fuel lines or
hoses.
NOTE
Use suitable container to catch any fuel that may leak out
whenever any part of fuel system is loosened or disconnected.
Use rags (Item 65, Appendix D) to wipe any spillage.
1.
Using both wrenches, disconnect both ends of line assembly (A) from adapters (B) and (C).
2.
Remove line assembly (A).
INSTALLATION:
1.
Make new line assembly (A).
2.
Position line assembly (A) to adapters (B) and
(c).
3.
Using both wrenches, install line assembly to
adapters.
4.
Operate primer pump (TM 9-2350-222-10) and
check for leaks. If leak is found, tighten
connection as required.
5.
Install lower engine access cover (page 16-42).
End of Task
7-414
