TM9-2350-222-20-1-3
ENGINE TO TRANSMISSION OIL LINE TUBE ASSEMBLIES (INNER AND OUTER)
REPLACEMENT (2D ENGINE) (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS: 1-1/2 in. open end wrench
Adapter, 1/2 in. female to 3/4 in. male
1-5/8 in. open end wrench
Handle with 3/4 in. drive
(5120-00-203-4802)
Torque wrench with 1/2 in. drive
1-5/8 in. socket with 3/4 in. drive
(0-175 ft-lb) (0-62N m)
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
SUPPLIES: Masking tape (Item 57, Appendix D)
Plastic barrier material (Item 41, Appendix D)
Rags (Item 65, Appendix D)
Gasket (4 required)
REFERENCE: LO 9-2350-222-12
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-25)
Remove engine shroud (page 9-2)
Remove rear engine shroud support (page 9-4)
NOTE
Right side shown, left side identical.
Go on to Sheet 2
Change 4
6-185
