TM9-2360-222-20-1-3
THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (LEFT SIDE)
TEST AND REPLACEMENT (2D ENGINE) (Sheet 4 of 6)
8.
Using 1-1/2 inch wrench, remove tube end
fitting (F) from adapter (H).
9.
Using hands, displace tube (K).
10. Using 1-5/8 inch wrench, remove adapter (H).
11. Using automotive wrench, remove valve
assembly and spacer ring (L), Throw spacer
ring away.
TEST:
1.
Using heat source (A), heat container (B) of
clean water to boiling.
2.
Using ruler, measure overall length of valve
at room temperature. Write down overall
length of valve.
3.
Using wire, wrap one end tightly around
threads (C) of valve,
4.
Place valve in boiling water just so valve is
covered. Let free end of wire hang over edge of
container.
5.
After about 30 seconds, use free end of wire to
take valve out of water.
Go on to Sheet 5
TA139544
6-177
