TM9-2350-222-20-1-3
ENGINE OIL COOLER INLET OR OUTLET HOSE REPLACEMENT (Shoot 1 of 3)
9/16 in. combination box and open end wrench
TOOLS:
3/8 in. combination box and open end wrench
1-1/2 in. open end wrench
9/16 in. open end wrench
3/4 in. combination box and open end wrench
Flat-tip screwdriver
Torque wrench with 3/8 in. drive (0-200 lb-in) (0-23 Nm)
3/4 in. socket with 3/8 in. drive
Drip pan
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
Dry cleaning solvent (Item 55, Appendix D)
SUPPLIES:
Washer (NAS1598-6V)
TM 9-2350.222-10
REFERENCES:
LO 9-2350-222-12
PRELIMINARY PROCEDURE:
NOTE
This procedure is to be used to replace either the inlet or
outlet oil line to either the loft or right l engine oil cooler.
Go on to Sheet 2
TA263186
Change 1 6-188.1