TM9-2350-222-20-1-3
THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (LEFT SIDE)
TEST AND REPLACEMENT (2D ENGINE) (Sheet 6 of 6)
7.
At other end of tube (E), using 1-1/2 inch
wrench, install tube end fitting (F) on adapter
(G).
8.
Using 1-1/2 inch wrench, tighten tube end
fitting (D) at oil cooler.
9.
Using 1-5/8 inch wrench, install adapter (H).
10.
Using hands, install tube end fitting (J) on
adapter (H).
11.
Go to other end of tube (K) and, using 1-1/2
inch wrench, install tube end fitting (L) on
adapter (M).
12.
Using 1-1/2 inch wrench, tighten tube end
fitting (J) at oil cooler.
Replenish oil lost during valve assembly
13.
replacement (LO 9-2350-222-12).
14.
Remove rags from transmission and oil cooler.
Start and run engine (TM 9-2350-222-10).
15.
Check for oil leaks.
Install engine shroud (page 9-3),
16.
17.
Install transmission shroud (page 9-23).
End of Task
All data on pages 6-180 thru 6-184 deleted.
6-179/(6-180 blank)
Change 4
