TM9-2350-222-20-1-3
THERMOSTATIC TRANSMISSION OIL COOLER VALVE ASSEMBLY (LEFT SIDE)
TEST AND REPLACEMENT (2D ENGINE) (Sheet 5 of 6)
Using ruler, measure overall length of valve. Write down overall length of valve.
6.
Compare measurements written down at room temperature and at heated temperature.
7.
WARNING
Compressed air used for cleaning purposes will not exceed 30
Use only with effective chip guarding and personal
psi.
protective equipment (goggles/shield, gloves, etc.).
Using low-pressure compressed air, dry valve.
8.
NOTE
After heating, valve length must have increased by 1/4 inch
minimum. If valve length increased less than 1/4 inch, throw
valve away. Obtain new valve and repeat test.
INSTALLATION:
Install new spacer ring (A) on valve (B).
1.
2.
Using hands, install valve (B) to transmission
oil cooler.
Using automotive wrench, tighten valve (B).
3.
Using 1-5/8 inch wrench, install inside
4.
adapter (C).
5.
Using hands, install tube end fitting (D) on
adapter (C).
6.
Go to other end of tube (E).
Go on to Sheet 6
TA139545
6-178
