TM 9-2350-222 -20-1-3
ENGINE) (Sheet 7 of 10)
TRANSMISSION OIL COOLER REPLACEMENT
5.
Position oil cooler screen (D) into place
on oil cooler. Install screw (D.1) and
washer (D.2).
NOTE
You will have bracket (D.3) and tube
(D.9) only if your vehicle is equipped
with a 2DA engine.
6.
Position bracket (D.3) to oil cooler.
6.1.
Install assembled washer screw (D.4).
6.2.
Using socket, tighten screws (D.1) and
(D.4).
6.3.
Using 3/4 inch wrench, install bolt (D.5).
6.4.
Using socket, extension, ratchet, and 1/2
inch wrench, install screw (D.6) and nut
(D.7) to secure clamp (D.8) and tube
(D.9) to bracket (D.3).
7.
Lift starter cable mounting bracket (E) into place at top of oil cooler.
8.
Start threads of four screws with new
lockwashers (F) by hand.
9.
Using socket, tighten four screws and
lockwashers (F).
Go on to Sheet 8
6-152
Change 4
