TM 9-2350-222-20-1-3
TRANSMISSION OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 5 of 10)
NOTE
You will have bracket (M) and tube
(M.1) only if your vehicle is
equipped with a 2DA engine.
15.
Using socket, extension, ratchet, and 1/2 inch
wrench, remove screw (M.2) and locknut (M.3)
securing clamp (M.4) and tube (M1) to bracket (M).
15.1.
Using 3/4 inch wrench, remove bolt (M.5).
15.2.
Using socket, remove assembled washer screw
(M.6), screw (M.7), and washer (M.8) securing
bracket (M) and oil cooler screen (M.9).
Remove bracket (M) and oil cooler screen
16.
(M.9).
CAUTION
Using another person, support oil cooler to keep it from falling
while doing steps 17 through 19.
17. Using 3/4 inch wrench, remove two screws and washers (N) holding oil cooler screen mounting
bracket (P) to oil cooler and oil cooler to oil cooler frame.
18. Remove oil cooler screen mounting bracket (P).
19.
Using 3/4 inch wrench, remove two screws and washers (Q) holding oil cooler to oil cooler frame.
20. Lift oil cooler away.
Go on to Sheet 6
Change 4
6-150
