TM 9-2350-222-20-1-3
TRANSMISSION OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 2 of 10)
REMOVAL:
NOTE
Removal procedures are the same for the right and left coolers
except that the upper rear mount bolt on the right cooler
additionally secures support bracket (A).
1.
Using screwdriver, loosen clamp (B) to remove
air inlet hose (C). Remove air inlet hose (C).
2.
Place cover over air inlet port to keep out dirt.
3.
Place drip pan or rags under transmission
connectors (D).
4.
Using 1-5/8 inch wrench to hold connector
(D) and, using 1-1/2 inch wrench, remove
hose (E) from transmission connectors (D).
5.
Using 1-5/8 inch wrench to hold connector
(D) and, using 1-1/2 inch wrench, remove
hose (F) from transmission connectors (D).
Go on to Sheet 3
TA139514
6-147