TM 9-2350-222-20-1-3
ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (2D ENGINE)
Sheet 2 of 4)
REMOVAL:
1.
Using 9/16 inch wrench, remove vent bolt (A)
and sealing washer (B).
2.
Throw washer (B) away.
Using 3/4 inch wrench, loosen oil drain valve
3.
(C) six complete turns.
4.
Using screwdriver and 3/8 inch wrench, remove
clamp (D) on hose (E) if clamp is attached to
hose. If clamp (D) is not attached to hose (E),
go to step 5.
5.
Using 1-1/2 inch wrench, remove fitting (F)
from connector (G).
6.
Using two 1-1/2 inch wrenches on hose (E) and
fitting (H), remove hose (E).
7.
Using 1/2 inch wrench, remove three
self-locking nuts (J) from connector (G).
8.
Throw three nuts (J) away
9.
Remove connector (G)
Go on to Sheet 3
TA139524
6-157
