TM 9-2350-222-20-1-5
MAGNETIC CLUTCH AND HOUSING REPLACEMENT (Sheet 1 of 6)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Cleaning and Inspection
Installation
5/16 in. socket head screw key
TOOLS:
1/2 in. combination box and
(allen wrench)
open end wrench
9/16 in. socket with 1/2 in. drive
3/8 in. combination box and
12 in. extension with 1/2 in. drive
open end wrench
Ratchet with 1/2 in. drive
1-1/8 in. combination box and
Slip joint pliers
open end wrench
Bearing puller
7/16 in. combination box and
Stud remover and setter
open end wrench
Center punch
3/4 in. combination box and
open end wrench (2 required)
Gasket (10940760)
Container (to catch fluid)
SUPPLIES:
Gasket (10940669)
Electrician's tape (Item 58,
Gasket (10940613)
Gasket (7383695)
Seal (10940820)
Dry cleaning solvent (Item 54,
Oil (Item 43, Appendix D)
Lockwasher (MS35338-26)
(14 required)
Lockwasher (MS35338-46)
(7 required)
Lockwasher (MS35338-48) (2 required)
REFERENCE: LO 9-2350-222-12
Remove right angle drive, clutch, and pump (page 18-101)
PRELIMINARY PROCEDURE:
CLUTCH
REMOVAL:
NOTE
Using center punch, scribe a mark
on housings to help aline parts at
installation.
1.
Place container under clutch housing to catch fluid.
2.
Using 3/8 inch wrench, remove plug (A).
3.
Using 5/16 inch allen wrench, remove plug (B) and allow clutch housing to drain.
Go on to Sheet 2
TA253663
