TM 9-2350-222-20-1-5
RIGHT ANGLE DRIVE REPLACEMENT (Sheet 4 of 5)
INSTALLATION:
1.
Place new lockwashers (A) on two screws (B).
2.
Position new gasket (C) and spacer assembly (D)
on right angle drive (E).
3.
Using 1/2 inch wrench, install two screws (B).
Place new lockwashers (F) on six screws (G).
4.
5.
Position new gasket (H) and clutch housing (J) on right angle drive (E).
Using 1/2 inch wrench, install six screws (G).
6
Place new lockwasher (K) on screw (L).
7.
Insert spider (M) in clutch housing (J) on output spline of right angle drive (E).
8.
9.
Wrap drive gear spline with three or more layers of electrician's tape (Item 58, Appendix D).
Using pliers, hold drive gear spline from turning, while using 9/16 inch socket to install screw (L).
10.
Go on to Sheet 5
TA141213
