TM 9-2350-222-20-1-5
RIGHT ANGLE DRIVE REPLACEMENT (Sheet 2 of 5)
Using 1/2 inch wrench, remove eight nuts (D) and lockwashers (E). Throw lockwashers away.
3.
NOTE
If necessary, tap clutch (F) gently with screwdriver and
hammer to separate from clutch housing (A).
Pull clutch (F) hose from clutch housing (A) and remove gasket (C). Throw gasket away.
4.
5.
Wrap drive gear spline with three or more layers of electrician's tape (Item 58, Appendix D).
6.
Using pliers, hold drive gear spline from turning while using 9/16 inch socket to remove screw (H)
and lockwasher (J). Throw lockwasher away.
7.
Pull spider (K) from clutch housing (A).
8.
Using 1/2 inch wrench, remove six screws (L) and lockwashers (M). Throw lockwashers away.
NOTE
If necessary, tap clutch housing (A) gently with screwdriver
and hammer to separate from right angle drive.
9.
Pull clutch housing (A) loose from right angle drive (B) and remove gasket (N). Throw gasket
away.
Go on to Sheet 3
TA141211
18-109