TM 9-2350-222-20-1-5
RIGHT ANGLE DRIVE, CLUTCH, AND PUMP REPLACEMENT (Sheet 6 of 8)
NOTE
If tube assemblies (G) and (H)
were removed from bracket (J),
perform steps 8 thru 10. If not,
go to step 11.
Place new lockwasher and flat washer on bolt
8.
(K).
9.
Have person hold tube assemblies (G) and (H) in
position shown.
Aline champs (L) and (M) and bracket (J) with
10.
tube assemblies (G) and (H), insert bolt, and
tighten finger tight. A 9/16 inch socket may be
used to snug the assembly together.
11.
Insert three packings (N) and packing (P) in
grooves indicated.
12.
Carefully position tube assemblies (G) and (H)
on pump (Q).
13.
Place new lockwashers and washers on eight
screws (R).
14.
Insert four screws (R) in flange of each tube
assembly (G) and (H) and tighten finger tight.
Go on to Sheet 7
TA141207
18-105
