TM 9-2350-222-20-1-5
RIGHT ANGLE DRIVE, CLUTCH, AND PUMP REPLACEMENT (Sheet 5 of 8)
INSTALLATION:
Install suction hose to rotary pump (page 18-115, steps 1 thru 4).
1.
2.
Attach sling and, using lifting device, position right angle drive (A) and attached parts over rear of
vehicle.
Position new packing (B) in groove of tube and fitting (C) in hull.
3.
Position new gasket (D) on face of right angle drive (A).
4.
NOTE
It might be necessary to move right angle drive back and forth
or to turn drive spline to aline to transmission.
Lower right angle drive (A) and attached parts to aline it at transmission.
5.
Insert five screws, new lockwashers, and washers (E) through flange of right angle drive (A) and
6.
gasket (D) and tighten finger tight.
Aline suction hose on tube end fitting (C) and insert four screws with new lockwashers (F) and
7.
tighten finger tight.
Go on to Sheet 6
TA14120