TM 9-2350-222-20-1-5
RIGHT ANGLE DRIVE, CLUTCH, AND PUMP REPLACEMENT (Sheet 3 of 8)
Remove tube assemblies (D) and (E) as an
7.
assembly with bracket (G).
Remove and throw away four packings (H).
8.
9.
Using rags, wipe all ports and tube ends clean
and tape them with masking tape (Item 57,
NOTE
Unless tube assemblies (D) or
(E) or bracket (G) require re-
placement, do not disassemble
them (steps 10 and 11).
10. Using 9/16 inch socket, remove screw,
lockwasher, and flat washer (J). Throw
lockwasher away.
11. Remove clamps (K) and (L), tube assemblies (D)
and (E), and bracket (G).
.
12. Using 3/4 inch wrench, remove four screws and
lockwashers (M). Throw lockwashers away.
Using 7/8 inch wrench, loosen nut of electrical
13.
connector (N) and pull connector loose.
Go on to Sheet 4
TA141204
18-102
