TM 9-2350-222-20-1-5
FRONT FENDERS, HEADLIGHT GUARDS, AND OUTRIGGERS REPLACEMENT (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS:
Ratchet with 1/2 in. drive
7/16 in. socket with 1/2 in. drive
7/16 in. combination box and open end wrench
9/16 in. socket with 1/2 in. drive
9/16 in. combination box and open end wrench
3/4 in. socket with 1/2 in. drive
3/4 in. combination box and open end wrench
1-1/8 in. socket with 3/4 in. drive
Ratchet with 3/4 in. drive
Torque wrench with 3/4 in. drive (0-600 lb-ft) (0-813 Nm)
SUPPLIES:
Lockwasher (MS35338-48) (2 required)
Lockwasher (MS35338-44) (13 required)
Lockwasher (MS35338-51) (8 required)
Self-locking nut (MS51988-7) (10 required)
PRELIMINARY PROCEDURES:
Remove personnel heater exhaust tube
(right fender only) (page 19-5)
Remove center stowage box (page 16-177)
REMOVAL:
NOTE
Right front fender, headlight guard, and outriggers shown.
Left front fender removal is similar.
Go on to Sheet 2
TA253573
