TM 9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
FEMALE RECEPTACLE REPAIR (Sheet 2 of 3)
7.
Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
solder well (F).
Placing connector face down on flat surface,
8.
apply a small amount of silicone (Item 32,
Appendix D) to empty holes on back of plug
assembly (B) and on front of grommet (D).
Push new contact (E) into hole in back of plug
9.
assembly (B) far enough so it will remain
standing.
10. Push jumper wire end through grommet
retaining nut (A) and then through hole in
grommet (D).
11. Hold jumper wire so wire end is pushing
down into solder in contact solder well (F).
12. Hold soldering gun tip against side of contact
(E) until solder begins to melt and wire slips
into contact solder well (F).
13. Removing soldering gun from side of contact
(E), continue holding wire until solder has
cooled and set.
Go on to Sheet 3
TA139875
10-324
