TM 9-2350-222-20- 1-4
ENGINE WIRING HARNESS REPLACEMENT (2D ENGINE) (Sheet 3 of 12)
6.
Using slip joint pliers and hands to loosen, disconnect electrical lead (CKT 86/GND) (G) from
ignition unit (H).
Using 1/2 inch socket, remove nut and lockwasher(J) securing clamp (hidden). Throw lockwasher
7.
away.
8.
Remove clamp from wiring harness (B).
9.
Using 1/2 inch socket, remove screw and
lockwasher (K). Throw lockwasher away.
10.
Remove clamp (L) from electrical wiring
harness (B).
11.
Using 1/2 inch socket, remove screw and lockwasher (M) securing ground lead (N). Throw
lockwasher away.
12.
Using 1/2 inch socket, remove screw and lockwasher (P). Throw lockwasher away.
13.
Remove clamp (Q) from wiring harness (B).
14. Using 1/2 inch socket, remove screw and lockwasher (R). Throw lockwasher away.
15. Remove clamp (S) from engine wiring harness (B).
16. Using 1 inch wrench, disconnect electrical connector (T) from generator (U).
GO on to Sheet 4
TA139892
10-341
