TM 9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
FEMALE PLUG REPAIR (Sheet 3 of 3)
11.
Hold jumper wire so wire end is pushing
down onto solder in contact solder well (F).
12. Hold soldering gun tip against side of contact
(E) until solder begins to melt and wire slips
into contact solder well (F).
13. Removing soldering gun from side of contact
(E), continue holding wire until solder has
cooled and set.
14. Using remover, push contact (E) into plug
assembly (B).
15. Sliding grommet (D) forward along cable (C),
set grommet (D) firmly against contacts (E).
16. Manually thread grommet retaining nut (A)
onto plug assembly (B).
17. Using multimeter, check continuity of repaired circuit.
18. Tighten or install cable clamps as required.
19. Connect connectors at each end of affected cable.
20. Connect three battery ground straps (page 10-283).
TA139871
End of Task
10-320
