TM 9-2360-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
FEMALE CONNECTOR WITH WASHER (12 GAGE CABLE) REPAIR (Sheet 1 of 1)
TOOLS: Electrical connector repair tool kit
Diagonal cutting pliers
PRELIMINARY PROCEDURES: Disconnect three battery ground straps (page 10-283)
Loosen or remove cable clamps as required
1.
Slide shell (A) back along cable (B).
Using diagonal cutting pliers, cut terminal
2.
(C) and washer (D) from cable (B). Throw
terminal (C) and washer (B) away.
Using hand wire stripper, strip insulation from
3.
cable (B) equal to well depth in terminal (C).
Slide new washer (D) onto stripped cable end
4.
(E) back to cable insulation.
Insert stripped cable end (E) into well in
5.
terminal (C).
6.
Using crimping tool, crimp terminal (C).
7.
Slide shell (A) forward until tight against washer (D).
8.
Using multimeter, check continuity of repaired circuit.
9.
Tighten or install cable clamps as required.
10.
Connect three battery ground straps (page 10-283).
End of Task
TA139872
10-321
