TM.9-2350-222-20-1-4
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR
FEMALE CONNECTOR WITH SLEEVE (14 AND 16 GAGE CABLE) REPAIR (Sheet 1 of 1
TOOLS: Electrical connector repair tool kit
Diagonal cutting pliers
Disconnect three battery ground straps (page 10-283)
PRELIMINARY
PROCEDURES:
Loosen or remove cable clamps as required
Slide shell (A) and sleeve (B) back along cable
1.
(c).
2.
Using diagonal cutting pliers, cut terminal
(D) from cable (C). Throw terminal (D) away.
Using hand wire stripper, strip insulation from
3.
cable (C) equal to well depth in terminal (D).
Insert stripped cable end (E) into well in
4.
terminal (D).
5.
Using crimping tool, crimp terminal (D).
6. Slide sleeve (B) forward along cable (C) until
tight against terminal (D).
Slide shell (A) forward along cable (C) until tight against sleeve (B).
7.
8.
Using multimeter, check continuity of repaired circuit.
Tighten or install cable clamps as required.
9.
10. Connect three battery ground straps (page 10-283).
End of Task
TA139873
10-322
