TM 9-2350-222-20-1-3
THERMOSTATIC ENGINE OIL COOLER VALVE ASSEMBLY (LEFT AND RIGHT)
REPLACEMENT (Sheet 1 of 4)
1-3/4 in. open end wrench
TOOLS:
Ruler
Low-pressure compressed air facility
Ground hop kit (Item 30, Chapter 3, Section I)
SPECIAL TOOLS:
SUPPLIES:
Cooking stove (mounted in vehicle)
Drip pan
12 in. length of scrap wire
Spacer ring (7403580)
Pencil
Paper
REFERENCE:
LO 9-2350-222-12
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-1)
Remove engine oil filter vent bolt and sealing washer
(page 6-130) 2D engine only
Drain engine oil 2A engine (page 6-49) 2D engine (page 6-51)
Loosen engine oil drain valve (page 6-130) 2D engine only
Disconnect and cover engine oil return hose and fitting
Remove left side engine oil cooler when left
thermostat is to be replaced 2A engine (page 6-122)
2D engine (page 6-130)
Go on to Sheet 2
TA253181
6-160 Change 1
