TM 9-2350-222-20-1-3
ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (2D ENGINE)
(Sheet 4 of 4)
5.
Using two 1-1/2 inch wrenches, install hose (E)
to fitting (F).
6.
Using screwdriver and 3/8 inch wrench, install
clamp (G) on hose (E) if removed during
disassembly.
Position new sealing washer (H) over vent hole.
7.
Using 9/16 inch wrench, install vent bolt (J)
8.
through washer (H).
9.
Using socket and torque wrench, tighten drain
valve (K) to 150 lb-in (17 N-m).
10. Perform ground hop (page 5-48). Run engine at
idle until oil temperature is in normal
operating range (TM 9-2350-222-10).
11. Check oil level. Add oil as required (LO
9-2350-222-12).
12. Disconnect ground hop kit (page 5-62).
13. Install powerplant (page 5-37).
End of Task
TA139526
6-159
