TM 9-2350-222-20-1-3
TRANSMISSION OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 1 of 10)
TOOLS: 1/2 in. socket with 1/2 in. drive
6 in. extension with 1/2 in. drive
. Ratchet with 1/2 in. drive
3/4 in. combination box and open end wrench
1-1/2 in. open end wrench
Flat-tip screwdriver
SPECIAL TOOLS: Ground hop kit (Item 30, Chapter 3, Section I)
SUPPLIES: Drip pan
Masking tape (Item 57, Appendix D)
Plastic barrier material (Item 41, Appendix D)
Rags (Item 65, Appendix D)
Cover for turbosupercharger air inlet port
Lockwasher (MS35335-34) (4 required)
REFERENCE: LO 9-2350-222-12
Remove powerplant (page 5-25)
PRELIMINARY PROCEDURES:
Remove engine shroud (page 9-2)
NOTE
Right side shown, left side
similar.
Go on to Sheet 2
TA139513
6-146
