TM
9-2350-222-20-1-3
ENGINE OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 5 of 6)
10.
Using 1/2 inch socket with extension through
harness and into bracket, install two washers
and screws (E).
Using 1/2 inch wrench, install oil cooler vent
11.
hose (F) at top of cooler.
Position new gaskets (G) and oil cooler
12.
connectors (H) onto cooler.
Remove plastic material (Item 41, Appendix D)
13.
and masking tape (Item 57, Appendix D) from
ends of hoses (G) and (J) and oil cooler
connectors (H) and (K).
Using 1-1/2 inch wrench, install hose (G) at oil
14.
cooler connector (H).
15.
Using 1-1 /2 inch wrench, install hose (J)
cooler connector (K).
Go on to Sheet 6
TA139501
6-134