TM 9-2350-222-20-1-3
ENGINE OIL COOLER REPLACEMENT (2D ENGINE) (Sheet 4 of 6)
INSTALLATION:
1.
Place oil cooler and oil cooler screen mounting
bracket into place on oil cooler frame.
Start threads of four screws with washers (A)
2.
by hand to hold oil cooler in place.
3.
Using 3/4 inch wrench, tighten screws (A).
4.
Lift screen into place on oil cooler.
5.
Start threads of four screws with washers (B) by
hand to hold oil cooler screen in place,
6.
Using 1/2 inch socket, tighten screws and
washers (B).
7.
Lift starter cable mounting bracket (C) into
place at top of oil cooler.
8.
Start threads of four screws with new
lockwashers (D) by hand.
9.
Using 1/2 inch wrench, tighten screws and
lockwashers (D).
Go on to Sheet 5
TA139500
6-133
