TM 9-2350-222-20-1-4
COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 1 of 5)
PROCEDURE INDEX
PAGE
PROCEDURE
Disassembly
Cleaning and Inspection
Assembly
Pinch bar
TOOLS: 9/16 in. socket with 1/2 in. drive
Drift punch
Impact wrench with 1 in. drive
Flat-tip screwdriver
Hammer
Torque wrench with 3/4 in. drive (0-600 lb-ft)
1/2 in. hinged handle
(0-814 N.m)
2-1/2 in. socket with 1 in. drive
Needle nose pliers
SPECIAL TOOLS: Handle, remover and replacer (Item 9, Chapter 3, Section I)
Replacer, oil seal (Item 19, Chapter 3, Section I)
Replacer, oil seal and retainer (Item 22, Chapter 3, Section I)
Wrench, hook spanner (Item 25, Chapter 3, Section I)
SUPPLIES: Grease (Item 36, Appendix D)
Seal (MS51912-2-9)
REFERENCES:
TM 9-2350-222-10
LO 9-2350-222-12
PRELIMINARY
PROCEDURE:
Go on to Sheet 2
TA141349
Change 1 14-67