TM 9-2350-222-20-1-4
COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 4 of 5)
Apply a light coat of grease (Item 36, Appendix
1.
D) to outside of seal (A).
Position new outer grease seal (A) into retainer
2.
(B) so BACK of seal is into retainer and FRONT
is facing away from retainer.
Using replacer and handle (Item 19 and 9,
3.
Chapter 3, Section I), tap seal (A) into place
in seal retainer (B).
4.
Coat upper spindle or arm, replacer, and seal
..
retainer (B) with grease (Item 36, Appendix
D).
Position replacer (Item 22, Chapter 3, Section
I) on upper spindle, flush with spacer (C).
6.
Slide seal retainer (B) over upper spindle and
replace unitl it is sealed on spacer (C).
Go on to Sheet 5
TA141352
14-70 Change 1