COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 3 of 5)
CLEANING AND INSPECTION:
Minor nicks, scratches, gouges, and pitting are
okay if they are not on machined surfaces.
Inspect bearings and cups for damage. Replace
Check seal assembly for rust, missing rivets, or
other damage. Replace seal where required.
Inspect all nuts, washers, and screws for wear
and damaged threads.
Inspect spacer and bearing sleeve on spindles
for scratches, nicks, or dents. If damaged,
notify support maintenance.
Identify FRONT and BACK of outer grease seal.
grease seal retaining lip can be pulled away from metal inner
edge on FRONT of seal. Pull back retaining lip on seal and
expose garter spring. BACK of seal has rubber grease retainer
bonded to metal case and cannot be pulled away.
Go on to Sheet 4
Change 1 14-69