TM 9-2350-222-20-1-5
SMOKE GENERATOR ELBOW-TO-SOLENOID FUEL HOSE REPLACEMENT (Sheet 2 of 2)
REMOVAL:
1.
Using 7/16 inch wrench to hold nut and 7/16 inch socket on screw, remove nut (A), lockwasher
(B), and screw (C) securing retaining straps (D), pads (E), and clamps (F) and (G).
2.
Remove retaining straps (D), pads (E), and clamps (F) and (G).
3.
Using 7/8 inch wrench, disconnect
elbow-solenoid hose (H) from elbows (J) and
(K).
Remove elbow-to-solenoid hose (H). Remove clamp (G) from hose.
4.
INSTALLATION:
Install clamp (G) onto elbow-to-solenoid hose (H).
1.
Position and connect elbow-to-solenoid hose (H) to elbows (J) and (K). Using 7/8 inch wrench,
2.
tighten hose (H) connections to elbows (J) and (K).
3.
Install pads (E), retaining straps (D), and clamps (J) and (K) to tube assemblies (L).
4.
Install screw (C), new lockwasher (B), and nut (A) to tube assemblies. Using 7/16 inch wrench to
hold nut (A) and 7/16 inch socket on screw, tighten screw (C).
WARNING
Never activate smoke generator in a building or closed area or
with personnel near.
5.
Perform smoke screening (TM 9-2350-222-10).
6.
Check smoke generator lines for leaks. Correct as necessary.
7.
Install engine shroud (page 9-3).
TA140889