SMOKE GENERATOR TEE-TO-TURBOSUPERCHARGER TUBE ASSEMBLY REPLACEMENT
(Sheet 3 of 5)
Using 3/4 inch wrench, disconnect solenoid
output fuel hose (H) from 90-degree elbow (J).
Using 9/16 inch wrench to hold tee (K), use 3/4
inch wrench and remove 90-degree elbow (J)
from tee (K).
Using 9/16 inch wrench to hold tee (K), use 5/8
inch wrench and disconnect tubes (L) from tee
Remove tee (K).
Using 1/2 inch wrench to hold adapter (M),
use 5/8 inch wrench and disconnect tube (L)
from adapter (M).
Remove tube (L).
Inspect adapter (M) in turbosupercharger
elbow for cracks or damaged threads. If
defective, use 1/2 inch wrench and remove
adapter (M) and throw it away.
Go on to Sheet 4