TACHOMETER SHAFT BULKHEAD ADAPTER REPLACEMENT (LATE MODEL) (Sheet 1 of 2)
15/16 in. combination box end open end wrench
1 in. combination box and open end wrench
3/4 in. combination box and open end wrench
SUPPLIES: Lockwasher (1 required)
Using 1 inch wrench, disconnect front flexible
shaft assembly (A) from bulkhead adapter (B).
Using 3/4 inch wrench, disconnect rear flex-
ible shaft assembly (C) from bulkhead adapter
Using 1 inch wrench to hold nut(C), use a
15/16 inch wrench to turn nut (D) and
remove adapter (B).
Go on to Sheet 2