TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (EARLY MODEL) (Sheet 3 of 7)
Using 7/16 inch wrench, remove lockwasher
screw (H) from clamp (J). Throw lockwasher
Remove clamp (J) from tachometer shaft (E).
compartment end of tachometer shaft (E).
Remove tachometer shaft (E) by pulling out
Using pliers, pull out core (A) approximately 2 inches from tachometer drive adapter end (B).
Using pliers, remove slotted washer (C) and gasket (D). Throw gasket away.
Using pliers, pull out core (A) from tachometer adapter end (E).
Remove flat washer (F) from adapter end (E).
Go on to Sheet 4