TM 9-2350-222-20-1-5
TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (EARLY MODEL) (Sheet 4 of 7)
CLEANING AND INSPECTION:
Using dry cleaning solvent (Item 54, Appendix D), clean all component parts.
1.
2.
Inspect all component parts for damage or wear and replace as required.
ASSEMBLY:
1.
Install flat washer (A) into tachometer adapter end (B).
Install core (C) through adapter end (B).
2.
3.
Using pliers, pull core (C) approximately 2 inches from tachometer drive end (D).
4.
Install slotted washer (E) and new gasket (F).
Push core (C) back into flexible shaft (G) until seated.
5.
NOTE
if replacing or installing plastic tubing on flexible shaft (G), do
steps 6 through 9. If not, go directly to INSTALLATION, Page
20-27.
TA25387
Go on to Sheet 5